Author Topic: Straightening rims (Read 510 times)

spectre · « **on:** April 17, 2008, 12:58 PM »

Ive got some araya 7x (or R - can't remember, the curved profile ones). Both have a gentle bend to one side, about 25cm worth of the wheel, 5mm up from a flat surface. this just a question of laying the rim over a pole or something and giving it a bit of shoving? Not massively confident as I've not had to straighten a rim I actually care about before

One's got a slight bend in the rim at one point also.

kdw712 · « **Reply #1 on:** April 17, 2008, 01:06 PM »

are they spoked up on hubs ?

if not then surely that could be pulled out with a bit smart spoke tensioning ?

subversion · « **Reply #2 on:** April 17, 2008, 03:01 PM »

You'll probably fook it up trying to straighten it like that & there's no reason a 5mm drift will not get pulled out when you build & tension it as mentioned above

spectre · « **Reply #3 on:** April 17, 2008, 05:32 PM »

Nah not spoked up, but I see what you mean, probably best to leave it to a bike shop to get them nice and straight etc. then

*puts down log/mallet*

Author Topic: Straightening rims (Read 510 times)

spectre

Straightening rims

kdw712

Re: Straightening rims

subversion

Re: Straightening rims

spectre

Re: Straightening rims