PM'd you the spoke size, regreasing the hubs is easy but its easier if you have a set of
cone spanners (thin spanner) put the cone spanner on the one nut closest to the hub
and a normal spanner on the locking nut and undo, becareful when removing axle as the
bearings are loose and will fall out everyway, clean bearing with petrol and on rag clean
inside of hub of dirt,shit anything, then regrease inside hub put a bit in there so that when you
insert the ball bearings they stick repeat both sides incert axle do up cone nut finger tight so axle
still moves the tighten lock nut
think thats it