Author Topic: burner headset problem (Read 1148 times)

magna13 · « **on:** May 31, 2007, 06:26 PM »

hi guys i finished my burner porject but when i went to go ride it the forks had loads of play in them. can anyone help??

spesh · « **Reply #1 on:** May 31, 2007, 06:29 PM »

did you use a db headset from halfrauds?because the bottom race is bigger than the burner one hence lots of slack
spesh

magna13 · « **Reply #2 on:** May 31, 2007, 06:31 PM »

i dont think i used a db one

probs though, what do you sugest i do to stop it

spesh · « **Reply #3 on:** May 31, 2007, 06:35 PM »

whip the forks off and check the fork race to see if its slack on the forks
ideally you should change it but in the meantime you can make a sleeve using coke cans and shim the bottom race to take out the slack

spesh

magna13 · « **Reply #4 on:** May 31, 2007, 06:47 PM »

thanks m8

selfpreservation · « **Reply #5 on:** June 01, 2007, 12:43 AM »

they were all like that BITD

Voodoocars · « **Reply #6 on:** June 01, 2007, 07:38 AM »

Measure the diameter of the forks where the crown race has to fit.It has to be a pretty acurate measurment so use a micrometer or good calipers.Then give this place a call, they have everything. Chandos Hub and Rim Co. 01279 758718
Ian.