Author Topic: Question about welding... calling all Sawzall's!!!! (Read 994 times)

Redline · « **on:** June 24, 2012, 05:45 PM »

I have recently purchased an old alloy SE frame which has a small amount of chain rub on one of the rear seat stays... apparently typical on these frames.

My question is if I have it filled with weld and then dress it up, will you see a fine outline of the shape where it was welded as I'm planning to have the frame annodised and want to know whether it will show up or not?

Cheers for any advice dudes

John

HUTCHMAN · « **Reply #1 on:** June 24, 2012, 06:02 PM »

no mate,with a bit of filing and re finishing it will dissappear.I've done exactly this on my straight stay ripper,on the drop outs. Were nearly obliterated by a freewheel fitted too close to the frame.

Redline · « **Reply #2 on:** June 24, 2012, 06:03 PM »

Quote from: HUTCHMAN on June 24, 2012, 06:02 PM

no mate,with a bit of filing and re finishing it will dissappear.I've done exactly this on my straight stay ripper,on the drop outs. Were nearly obliterated by a freewheel fitted too close to the frame.

Cheers fella

region11 · « **Reply #3 on:** June 24, 2012, 07:03 PM »

I have the same small amount of chain rub on my ripper and to be honest once built up you dont notice it at all

.

Twesnik · « **Reply #4 on:** June 24, 2012, 08:36 PM »

Hmmmm,welding!
It´s not about the filling,that´s easy for someone who known´s how to weld diff.material´s!
Should known this,i´m a master-welder......
It´s all about the kraftmanship after-ward´s!