Author Topic: restoring mx1000's (Read 893 times)

benno · « **on:** May 22, 2012, 10:22 PM »

Hi guys just stripped and painted my mx 1000's and put a new decal over the stamped dia compe bit ,
BUT now i want to paint in the MX bit anyone got any ideas the best way or is it a case of tiny brush and a steady hand
or a blue sharpie pen or the like

cheers Benno

sid1972 · « **Reply #1 on:** May 22, 2012, 10:25 PM »

I use a paint pen, any that goes over the edges can be rubbed off. I then use clear varnish with a fine brush to seal it.

benno · « **Reply #2 on:** May 22, 2012, 10:40 PM »

yeah gonna have a look at what size tips i can get sharpie's in ,
i was planning on laquering them after so that will seal it in
cheers Benno

bobbbbsy · « **Reply #3 on:** May 22, 2012, 10:46 PM »

sid1972 · « **Reply #4 on:** May 22, 2012, 10:48 PM »

your better off with a large flat nib and paint over the surface - rub the excess off when its been on a few minutes. Use the flat edge of a knife wrapped in a tight cloth. This leaves the paint in the recess.

hope that make sense.