FINALLY GOT ME SOME S&M PEDALS.

[dordymush]

been after a nice set of these for yonks.
i know others have em. but iv'e been looking for ages for a NOS set.
might try and get the end caps repo'ed for my old used pedals to restore.
what would be the best way to go about it i wonder ?.




 

[SaMAlex]

Did you know there are 2 versions of these pedals. One with moulded pins (like yours) and ones with screw in pins. I'm not sure which were earlier, or if its something to do with if they are sealed bearings?

[dordymush]

i just went into my spare bits and my old rough set are the screw in type.never relised when i bought these last night.
wonder which is the older then.
pity they not dated like the ole DX's 

[Jaymz]

I bet Rakas could knock you up a set of end caps fella

[dordymush]

to say they sit in the pedal a bit on these mine are rough as owt on my old un's.
i just had a word with a mate on here that has a plastic cutter machine.
if i could get some disks cut out with the sheild on i think i could do something with them.
fingers crossed.

[Betty]

I've got a red pair with the screw in pins, they're unsealed bearings i'm guessing, they're virtually seized thanks to a day out at coppull on one of the wettest days ever!

Couldn't be arsed to strip and clean em up so i just put another pair of pedals on 

[dordymush]

idle arse  .
yeah the set i have are unsealed so yours will be welded together by now i should think  .
 

[Betty]

Found a pic, they don't look too bad



This thread has reminded me they need sorting 

[dordymush]

lol look at the state of that 

[kev-s]

dont look like that anymore!!!

[Gish]

would'nt mind a set of these myself