Author Topic: DX pins (Read 1045 times)

Moza · « **on:** March 29, 2011, 12:38 PM »

is there anything out there to replace damaged pins

?

NORTY40 · « **Reply #1 on:** March 29, 2011, 12:43 PM »

is there anything out there to replace damaged pins ?

Sure i have heard that people have used welding rod in the past $:-\$

Someone will confirm im sure

Moza · « **Reply #2 on:** March 29, 2011, 12:53 PM »

Thanks im sure welding rods are a bit thin. Im gonna have a look at some mesh at work

mattfx81 · « **Reply #3 on:** March 29, 2011, 12:58 PM »

Stick welding (MMA) electrodes start at 1.6mm and the next up are 3.25mm then 4mm.

TwoBobRob · « **Reply #4 on:** March 29, 2011, 10:35 PM »

I think I might have some Moza - how many do you need?

Moza · « **Reply #5 on:** March 29, 2011, 11:16 PM »

Enough to do two pedals

im not sure how many that is I will look tomorrow

TwoBobRob · « **Reply #6 on:** March 30, 2011, 02:07 PM »

I can say some confidence I don't have a full two pedals worth.... I'll dig them out later and have a count up anyway

Moza · « **Reply #7 on:** March 31, 2011, 12:20 AM »

I can say some confidence I don't have a full two pedals worth.... I'll dig them out later and have a count up anyway

Great thanks