Author Topic: help removing old bb (Read 778 times)

dodger · « **on:** September 16, 2010, 09:34 PM »

as titled i cant seem to get my old 3pc bb and cups out the frame
tried flat screwdriver from the back and a hammer and broke both aswell as almost my finger from geting a full man swing on it
sloted a solid t bar in and hit flat out with a pipe wrench and still nothing

......any ideas? not worried about frame paint condition aslong as its going to be a rat bike anyway.

rollin72 · « **Reply #1 on:** September 16, 2010, 09:40 PM »

soak in wd40 for a bit first maybe

dodger · « **Reply #2 on:** September 16, 2010, 09:46 PM »

i already have used abit
might have to drench it and see how it goes in the morning.

john4130 · « **Reply #3 on:** September 16, 2010, 10:22 PM »

hope it's not a euro bb

dodger · « **Reply #4 on:** September 17, 2010, 08:49 AM »

lol no its a old usa cub and cartridge bearing

MartyC · « **Reply #5 on:** September 17, 2010, 02:19 PM »

Try using a large brass drift, hit it north, south, east then west then repeat, get even pressure all round the cup

moley · « **Reply #6 on:** September 17, 2010, 03:01 PM »

Quote from: Glen on September 17, 2010, 02:32 PM

Brute force and a large hammer, they will eventually come loose

Yarp!!

But dont use a screwdriver.............use an extension bar off a socket set with the 1/4" rounded square end at the cups.

Bigger the hammer the easier it will be!!

And when you reinstall some cups..................grease them and the BB. It will make life easier when you have to remove/install them.

dodger · « **Reply #7 on:** September 17, 2010, 04:41 PM »

have managed tp smash one of the bearings to pieces so can now get somthing brutal in there as a 19mm hole is not much to work with esp when the center tube is fitted

these cups have been in best part of 10 years as its an old s&m holmes just being a bitch.