RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: motomagII on December 07, 2005, 06:25 PM

Title: cable fitting
Post by: motomagII on December 07, 2005, 06:25 PM

well i just got new set gyro cables for me haro .any tips etc for changing as havent got a clue what to do .new school is gibberish to me still .lol

Title: Re: cable fitting
Post by: Rombloke on December 07, 2005, 06:31 PM

gregg ive always done this....

fit cables, then take up any slack at the rear and ip the bolt up....then work forwards from the back of the bike, finishing at the lever adjuster.....then once all is fettled tighten rear bolt down properly

Dave

Title: Re: cable fitting
Post by: weston on December 07, 2005, 06:38 PM

i'll come & fit them this week if you need a hand...

Title: Re: cable fitting
Post by: lazychubs on December 07, 2005, 07:10 PM

wot dave said but i leave one adjuster wound out 2 turns
 then tighten it all up then loosen the adjuster

Title: Re: cable fitting
Post by: kusam on December 07, 2005, 08:39 PM

 :wtf:

I'd have to take it to a bike shop  :-[