Author Topic: primo power bite removal (Read 639 times)

Glen · « **on:** September 04, 2009, 05:06 PM »

Do Just hammer like fook on the axle to get it out of the BB?

fouronethreeoh! · « **Reply #1 on:** September 04, 2009, 05:32 PM »

Assuming the arms are off, squirt loads of wd40 in between spindle/bearings, then twat away!
Probably rusted in a bit.

motomagII · « **Reply #2 on:** September 04, 2009, 05:45 PM »

put the crank bolt back in then hit it with hammer so as not to damage the axle .they are quite tight but once moving it gets easier

MartyC · « **Reply #3 on:** September 04, 2009, 05:48 PM »

Poor boiling water over the crank end, alloy expands quicker than steel so you should be able to get some "give" on them

magna13 · « **Reply #4 on:** September 04, 2009, 05:58 PM »

Be sure to use a woodne/rubber/plastic mallet as these need alot and i mean of hitting to get off! even with WD40

MartyC · « **Reply #5 on:** September 04, 2009, 06:02 PM »

Get some diesel in there too, not WD40

MartyC · « **Reply #6 on:** September 04, 2009, 06:38 PM »

the BB is tigher than a nuns cnut though. Its the original