gfxgfx
 
logo
 
gfx gfx
gfx
975811 Posts in 138943 Topics by 6371 Members - Latest Member: Robertflamn November 28, 2024, 10:53 PM
*
gfx* Home | Portal | Forum | Merchandise | Help | Login | Register | gfx
gfx
RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  Can I totally strip a coaster hub?
gfx
gfxgfx
 

Author Topic: Can I totally strip a coaster hub?  (Read 750 times)

0 Members and 1 Guest are viewing this topic.

Daletsunami

  • Guest
Can I totally strip a coaster hub?
« on: April 07, 2009, 07:04 PM »
I've got a suntour coaster hub that I am wanting to strip down for some work and wondered if I can fully strip it in order to make this easier.

Any advice?

Offline meticulous

  • Berm Worm
  • ***********
  • Posts: 9509
  • Rated:
Re: Can I totally strip a coaster hub?
« Reply #1 on: April 07, 2009, 07:10 PM »
yes you can, just remember how it came apart, it can pretty much only go back together one way.....
R.I.P  O.M. Far short of the finish line...

snav69

  • Guest
Re: Can I totally strip a coaster hub?
« Reply #2 on: April 07, 2009, 07:11 PM »

Daletsunami

  • Guest
Re: Can I totally strip a coaster hub?
« Reply #3 on: April 07, 2009, 07:55 PM »
Cheers for that :daumenhoch:

I have managed to get most of it stripped now and have drawn my own diagram on what goes where so I can put it back together but the brake lever is not going nowhere, is that normally the difficult bit?

mark 2

  • Guest
Re: Can I totally strip a coaster hub?
« Reply #4 on: April 07, 2009, 09:48 PM »
http://www.wtlw.net/ff/suntour/

 :coolsmiley:

That's well handy Snav, Dale they're a right bugger to put back together

adeshere

  • Guest
Re: Can I totally strip a coaster hub?
« Reply #5 on: April 08, 2009, 01:07 AM »
Just remember to put the pads in the right way around

subversion

  • Guest
Re: Can I totally strip a coaster hub?
« Reply #6 on: April 09, 2009, 11:21 AM »
Cheers for that :daumenhoch:

I have managed to get most of it stripped now and have drawn my own diagram on what goes where so I can put it back together but the brake lever is not going nowhere, is that normally the difficult bit?

I take it you mean the brake 'arm' which attaches to the chain stay of the frame? If so then this sits over the inner cone of the hub like a spanner would. You just need to hold it to undo the outer lock nut non drive side & it should just come off of the inner cone/race assy. Few taps with a rubber mallet will shift it if it's stuck :daumenhoch:

RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  Can I totally strip a coaster hub?
 

gfxgfx
gfx gfx
Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
SimplePortal 2.3.5 © 2008-2012, SimplePortal