Author Topic: Can I totally strip a coaster hub? (Read 747 times)

Daletsunami · « **on:** April 07, 2009, 07:04 PM »

I've got a suntour coaster hub that I am wanting to strip down for some work and wondered if I can fully strip it in order to make this easier.

Any advice?

meticulous · « **Reply #1 on:** April 07, 2009, 07:10 PM »

yes you can, just remember how it came apart, it can pretty much only go back together one way.....

snav69 · « **Reply #2 on:** April 07, 2009, 07:11 PM »

http://www.wtlw.net/ff/suntour/

Daletsunami · « **Reply #3 on:** April 07, 2009, 07:55 PM »

Cheers for that

I have managed to get most of it stripped now and have drawn my own diagram on what goes where so I can put it back together but the brake lever is not going nowhere, is that normally the difficult bit?

mark 2 · « **Reply #4 on:** April 07, 2009, 09:48 PM »

Quote from: snav69 on April 07, 2009, 07:11 PM

http://www.wtlw.net/ff/suntour/

That's well handy Snav, Dale they're a right bugger to put back together

adeshere · « **Reply #5 on:** April 08, 2009, 01:07 AM »

Just remember to put the pads in the right way around

subversion · « **Reply #6 on:** April 09, 2009, 11:21 AM »

Quote from: Daletsunami on April 07, 2009, 07:55 PM

Cheers for that

I have managed to get most of it stripped now and have drawn my own diagram on what goes where so I can put it back together but the brake lever is not going nowhere, is that normally the difficult bit?

I take it you mean the brake 'arm' which attaches to the chain stay of the frame? If so then this sits over the inner cone of the hub like a spanner would. You just need to hold it to undo the outer lock nut non drive side & it should just come off of the inner cone/race assy. Few taps with a rubber mallet will shift it if it's stuck