gfxgfx
 
logo
 
gfx gfx
gfx
975804 Posts in 138943 Topics by 6363 Members - Latest Member: V6 DOW November 22, 2024, 10:48 PM
*
gfx* Home | Portal | Forum | Merchandise | Help | Login | Register | gfx
gfx
RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  nitromors
gfx
gfxgfx
 

Author Topic: nitromors  (Read 1059 times)

0 Members and 1 Guest are viewing this topic.

Offline 20to26

  • Site Supporter
  • Look Back
  • *
  • Posts: 1276
  • Rated:
nitromors
« on: March 20, 2009, 07:55 PM »
will this stuff remove red paint that has been splashed on a black Bulldog caliper without damaging the original black?
If not any ideas what will?
Thanks

Offline meticulous

  • Berm Worm
  • ***********
  • Posts: 9509
  • Rated:
Re: nitromors
« Reply #1 on: March 20, 2009, 08:22 PM »
gently use thinners first, as nitromores is very aggresive and could damage the original finish....
R.I.P  O.M. Far short of the finish line...

steve Beech TA

  • Guest
Re: nitromors
« Reply #2 on: March 20, 2009, 08:50 PM »


Sorry mate i cant think of anything that will do the job, if it takes the red of it will take the black of  or effect the finish :-\

steve Beech TA

  • Guest
Re: nitromors
« Reply #3 on: March 20, 2009, 08:51 PM »

What about stripping the lot take to bits and re spray it aint that hard and may be easier in the long run  :daumenhoch:

Offline 20to26

  • Site Supporter
  • Look Back
  • *
  • Posts: 1276
  • Rated:
Re: nitromors or oven pride?
« Reply #4 on: March 21, 2009, 12:23 PM »
thanks guys, I'll try thinners first and then the respray route.

Will Nitromors remove paint & rust off an old steel chainring that needs a respray? Or should I try Oven Pride for that?

 :daumenhoch:

Offline meticulous

  • Berm Worm
  • ***********
  • Posts: 9509
  • Rated:
Re: nitromors
« Reply #5 on: March 21, 2009, 05:07 PM »
chainring will most probably be anodice, so oven pride on that normally....  but if there is rust on it, it will be a steel chainring so nitromores on that...
R.I.P  O.M. Far short of the finish line...

Offline Stodgy

  • BMX Overlord
  • ***********
  • Posts: 15931
    • RADBMX Shop
  • Rated:
Re: nitromors
« Reply #6 on: March 21, 2009, 05:10 PM »
I think Bulldogs are powder coated so you'll probably be okay. Don't hold me to it though!!

Try a little spot of the 'mors on the back of the brake and leave it for 10mins to see if it starts to lift.


RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  nitromors
 

gfxgfx
gfx gfx
Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
SimplePortal 2.3.5 © 2008-2012, SimplePortal