Author Topic: nitromors (Read 1069 times)

20to26 · « **on:** March 20, 2009, 07:55 PM »

will this stuff remove red paint that has been splashed on a black Bulldog caliper without damaging the original black?
If not any ideas what will?
Thanks

meticulous · « **Reply #1 on:** March 20, 2009, 08:22 PM »

gently use thinners first, as nitromores is very aggresive and could damage the original finish....

steve Beech TA · « **Reply #2 on:** March 20, 2009, 08:50 PM »

Sorry mate i cant think of anything that will do the job, if it takes the red of it will take the black of or effect the finish $:-\$

steve Beech TA · « **Reply #3 on:** March 20, 2009, 08:51 PM »

What about stripping the lot take to bits and re spray it aint that hard and may be easier in the long run

20to26 · « **Reply #4 on:** March 21, 2009, 12:23 PM »

thanks guys, I'll try thinners first and then the respray route.

Will Nitromors remove paint & rust off an old steel chainring that needs a respray? Or should I try Oven Pride for that?

meticulous · « **Reply #5 on:** March 21, 2009, 05:07 PM »

chainring will most probably be anodice, so oven pride on that normally.... but if there is rust on it, it will be a steel chainring so nitromores on that...

Stodgy · « **Reply #6 on:** March 21, 2009, 05:10 PM »

I think Bulldogs are powder coated so you'll probably be okay. Don't hold me to it though!!

Try a little spot of the 'mors on the back of the brake and leave it for 10mins to see if it starts to lift.