profile box cranks spacer

[Glen]

Ive attempted to install the new Profile retro box cranks into a 2008 Skyway TA, but Ive used both supplied tube spacers and theyre both too short.
Ive used a new sealed profile BB and the cups and bearings are installed flush and neatly.  When I install and fasten the arms down, you can hear the spacer moving inside the BB shell and im using the longer silver 53mm spacer.  Now what?  Alans longest are 53mm

[fouronethreeoh!]

Could add one of the crank arm spacer/washer things inside the bottom bracket aswell as the tube.
Fiddly as hell i guess, i have made a new spacer before out of an old 7/8 inch seatpost, the profile spindle fits a treat.
Just hacksaw a length off and file down to required length.

[fouronethreeoh!]

Its probably more to do with the bb shell width of your frame which is leaving a gap when its all fitted.
Only takes a small gap and it wont tighten up properly, i had this problem with one of my bikes, making a longer tube cured it.
The tube ended up 0.5mm longer than a standard one.