Author Topic: BMX shops in Surrey/Hampshire?? (Read 938 times)

Linus27 · « **on:** September 13, 2008, 11:17 PM »

Are there any decent BMX shops in Surrey/Hampshire?? I see Farnborough has one oppersite Argos but no idea if any good. Any others about?

kev-s · « **Reply #1 on:** September 14, 2008, 05:00 AM »

the only real decent bmx shops i know of is pijin in southampton and coopers in cosham just outside portsmouth

evamedia · « **Reply #2 on:** September 14, 2008, 08:10 AM »

Deane's in Beckenham has got quite a large BMX section, I know it's Kent, but not far from the top of Surrey

Moose · « **Reply #3 on:** September 14, 2008, 09:12 AM »

Quote from: kev s on September 14, 2008, 05:00 AM

the only real decent bmx shops i know of is pijin in southampton and coopers in cosham just outside portsmouth

I've used both of these and they're spot-on

There's another in New Milton, but I've never been there and forgot what it's called

stuntmaster · « **Reply #4 on:** September 14, 2008, 09:26 AM »

there one in tolworth .on the road towards kingston .can`t remember what it`s called tho ,have a few bits in store and loads of mountain bikes.

sawzall · « **Reply #5 on:** September 14, 2008, 10:49 AM »

must agree with kev s pijin in southampton is a good shop they also do a great wheel building service

Linus27 · « **Reply #6 on:** September 14, 2008, 11:06 PM »

Thanks everyone

I need someone to look at my rear wheel as I was trying to get it lined up and I accidently undone the bolts that go into the spindle and some of the ball bearings fell out. I think i got them all put back but its not running as smooth as it should.

muttley · « **Reply #7 on:** September 15, 2008, 01:48 PM »

Halfords sell the bearings separately, there in yellow packs.

Linus27 · « **Reply #8 on:** September 15, 2008, 02:11 PM »

Quote from: MUTTLEY on September 15, 2008, 01:48 PM

Halfords sell the bearings separately, there in yellow packs.

Thanks Muttley, thats good to know. My only problem is I am not really sure what I am doing. I know on each end of the spindal there are two nuts which screw down onto the ball bearings and into the hub but I have no idea how tight etc or how it should go. So I kind of feel it might be worth taking it to an expert, especially as I need my bike for the Creation Novice night in two weeks.