An alternative to smacking headsets into show bikes with a hammer (pics)

[Jazzchimp]

Came up with a solution today to fitting the old headsets to show bikes as a substitute for a headset press, which I don’t have.

I got a piece of all-thread, a block of wood for the bottom, a washer for the top (which just fits into the cup) and a socket.

Tightened up the nuts (no need to overtighten) and tapped the cup, then tightened and tapped and so on. Kept on till it was home. Popped in a treat and never touched the paint.

I was so chuffed with myself 

Told you guys I was anal!!

[dordymush]

where did you get the threaded bar from.

[ORB]

the threaded bar shop.

[dordymush]

you would think i would learn by now would'nt you  .

[danny silverstreak]

Theres you messing about with bmx bikes and there is a basket full of ironing to do there jazz

[stidds]

I have been using this method for years Jazz, it is better than hitting it with a hammer though.

[Bren Gunn]

Builders merchant for the threaded bar... try Travis Perkins, they sold it when I worked for them last year

[dordymush]

cheers bren a sencible answer for a change 

[Nosnod]

Loving that full padset.. is it a cal-lite?!!!  ;

[danny silverstreak]

 

[Dingobmxer]

Hmmmm black Ripper per chance??
  DINGO

[TwoBobRob]

Threaded bar from any engineers supplies shop.  Another alternative is a 6" bench vice which you can use as a press. Just make sure jaw faces are fitted with some protection so as not to damage yer cups....

Personally,  I use a hydraulic press. Job's a good 'un 

[Jazzchimp]

Padding is another of my hot tips for maximum protection.

All-thread is available from most building merchants like Bren says.