Author Topic: anyone restored a seat info wanted (Read 772 times)

harris · « **on:** June 20, 2008, 11:25 PM »

i need to know the best grade of sand paper to smooth my seat out before i dye it.

steve Beech TA · « **Reply #1 on:** June 21, 2008, 06:18 AM »

Depends on what type of seat it is and the finish on it i suppose, to get the deep scratches out use 600 then go down to 1200. I used 1200 on my one but it only had very very light marks, cant tell it been rubbed down at all.

For the shiny or smooth bits on the side i used 1200 and it went dull so i then gently polished it with the polishing mop and a cutting paste to make it shiny again then gave it a good going over with a plastic restore. its not turned out to bad can relly tell its been done.

hope it helps

steve Beech TA · « **Reply #2 on:** June 21, 2008, 06:27 AM »

Ps

It took a long time to polish the sides but the idea is to keep the cutting compound wet while you polish, i think i then used my pink polish soap as well with the soft mop.

sawzall · « **Reply #3 on:** June 21, 2008, 08:06 AM »

dan if the above dosen't work and depending on seat you can always paint it aslong as you use a plastiflex primer and matting agent if needed,i did this on my ripper

lazychubs · « **Reply #4 on:** June 21, 2008, 08:10 AM »

didnt one of the burner boys do a seat
that came out really good

Steve P · « **Reply #5 on:** June 22, 2008, 12:59 AM »

Dan ... I used the normal grades of wet 'n' dry and finished with a 2000 grade paper to smooth things off

BEFORE

AFTER

Steve

Brandy Truffle · « **Reply #6 on:** June 22, 2008, 03:47 AM »

Russ on the Burner Forums does a cracking job by the looks of things... sure he's on here somewhere too....

Ahhh..here it is just found it.. Check this..Pics n all

http://www.radbmx.co.uk/forum/index.php'topic=56633.0