Could I just tighten this up?

[scary_leary]

Or do I need a 14 to 10mm tophat washer?

cheers

[SaMAlex]

I think you will need a .......

Top Hat
The most effec-tu-al Top Hat
Who's intellectual close friends get to call him T. H.
Great for when you need to fill space
Top Hat
The indisputable leader of the gang
He's the boss
He's the VIP
He's a championship
He's the most tip top -  Top Hat

Yes he's the chief
He's the king, but above everything
He's the most tip top - Top Hat!

[kuwahero]

you could but I wouldnt recommend it. get the washers otherwise you will only regret it.

trust me I wrecked a Hoffman Suger Baby doing the same thing with some shimano dx race hubs and fooked the hubs too.

[oberonspacefruit]

lol @ alex


you could just tighten it, i would ride it that way, but i reckon it will loosen off faster, and will strip the threads quicker.

[Moose]

just make sure you get the right ones 

[dan-dare]

Is it a redline fork??

[TwoBobRob]

I think you will need a .......

Top Hat
The most effec-tu-al Top Hat
Who's intellectual close friends get to call him T. H.
Great for when you need to fill space
Top Hat
The indisputable leader of the gang
He's the boss
He's the VIP
He's a championship
He's the most tip top -  Top Hat

Yes he's the chief
He's the king, but above everything
He's the most tip top - Top Hat!

That,  was genius  

I was singing along and everything!


Lots of people just tighten them up and go riding.  I would suggest a good quality 10mm penny washer or similar to spread the load of the smaller nut to help things out.  

[scary_leary]

Is it a redline fork??  

No Dan a late 80's robinson.
Moose i hear that.. i fitted a 14-10mm in a Gt fork and the forks drops were slightly smaller than 14mm..
was a right ball ache fileing the drops to make it fit.
I think these are the same type of dropout.. fook it as bob said, tighten them with a big washer 

[Moose]

I'm pretty sure they'll not be 14mm if they're from a late 80's Robo

[OrgasmDonor]

a 14mm wont fit thro the slot, a decent washer either side would do it tho

[scary_leary]

A 14mm will go.. you have to put them on either side of the axle, like washers
put your wheel in ..then push them in

[motomagII]

my gt frame was like that never did get the washers for it lol

[Rombloke]

A 14mm will go.. you have to put them on either side of the axle, like washers
put your wheel in ..then push them in

shut it you twat put em on the outside under the wheel nut.

Dave

[scary_leary]

and i thought bill curtin was a muggy c**t..     

[jT Racing]

 

[Bob_Acid]

Alex you need to get out more