Bar ID Please

[munners]

Hi all,

Finally got some pics together of some bars i have. Need them id'd if poss. I am resisting taking some pics of 2 bikes that i have finally got to my new house! I will take pics when they ALL arrive.

The measurements are  :

25.5" across from end to end.
7.25" from the bottom to the top of the cross bar.
Cross bar is half an inch thick.
The rest of the tubing is a fraction under an inch.







They have no knurling or stamp anywhere!

Hope this helps.

Nick 

[munners]

 

[munners]

Come on! 

[munners]

Bump

[adenough]

robinson?

[munners]

Anyone else?

[jT Racing]

? they look a bit gt'ey starbar'ey etc etc etc etc etc etc etc etc etc etc etc etc etc etc etc

[gossa]

defo not stars or early robinsons, are they brazed there?  Looks a bit chunkily put togther for tig, have you got a closer piccy of the weld/braze?

[animal]

Asuming they are braized as they look it. Have the ends been cut? If not they could be MRD or Rickman Expert bars. The cross brace is to small by 1/8th of and inch to be pro bars. Or could be Curtis.

[munners]

As you look at the bars in the pic the left hand end has been cut at an angle?

[OrgasmDonor]

they are, by what ive seen, a very similar shape to free agent bars, might be worth gettin a comparison

[dan-dare]

Profile?

[OrgasmDonor]

Profile?

Profile?  here ya go dude:
they are handle bars
for a bike
they are chrome
they are older
they are used to steer round dog toffee
you can over tighten them
they are good for putting grips on to

is that more or less what you wanted dan

[Frosty]

not os profiles, see below the 2nd from top are champ pro bars

[jT Racing]

they could be mild steel, mig welded generic shite.