gfxgfx
 
logo
 
gfx gfx
gfx
975811 Posts in 138943 Topics by 6371 Members - Latest Member: Robertflamn November 28, 2024, 06:59 PM
*
gfx* Home | Portal | Forum | Merchandise | Help | Login | Register | gfx
gfx
RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  How do I use this bb spindle?
gfx
gfxgfx
 

Author Topic: How do I use this bb spindle?  (Read 586 times)

0 Members and 1 Guest are viewing this topic.

scary_leary

  • Guest
How do I use this bb spindle?
« on: October 08, 2007, 11:04 PM »
Might look a tit here, but i dont understand how this spindle works with the bearings.

On the right u can see a machined type washer with the thread behind.. usually the thread is in front.

Hmmm



dj_benice

  • Guest
Re: How do I use this bb spindle?
« Reply #1 on: October 08, 2007, 11:11 PM »
check the diamater,from memory last un I had like that the side where the machined washer is was bigger so the the threaded bearing/retainer or whatever slides over the first thread before tightening on the bottom un......    I may also look like a tit here as my meory sucks  :LolLolLolLol:

bof

  • Guest
Re: How do I use this bb spindle?
« Reply #2 on: October 08, 2007, 11:11 PM »
Lee its just like fitting a one piece BB without the sprocket if that makes sense , obviously the chainwheel will be on the crank arm. :daumenhoch:

scary_leary

  • Guest
Re: How do I use this bb spindle?
« Reply #3 on: October 09, 2007, 07:17 AM »
Cheers for the info...err
yeah i think im up to speed.. Bof i hear what your saying.. yeah i get it now.. just.  :-[

Offline Bananaman

  • BMX Nerd
  • *********
  • Posts: 4795
  • Le Mans Man
  • Rated:
Re: How do I use this bb spindle?
« Reply #4 on: October 09, 2007, 08:42 AM »
Isn't that the same principle as a HLT set up?? the washer pulls up against the inside of the drive side bearing and the thread on the other end is on the outside of the none drive side tightning the whole lot in????? again I could be also looking mamory like :-[

theRuler

  • Guest
Re: How do I use this bb spindle?
« Reply #5 on: October 09, 2007, 09:00 AM »
it works exactly like an OPC, like bof said

RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  How do I use this bb spindle?
 

gfxgfx
gfx gfx
Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
SimplePortal 2.3.5 © 2008-2012, SimplePortal