Author Topic: skyway axle NOW WITH PIX (Read 575 times)

priv · « **on:** July 17, 2007, 10:20 AM »

i've got a front plastic hubbed skyway i'm thinking of using but the cones don't tighten up properly on one side,it's the washer that holds the bearings in place that's worn,do i need to buy a full axle kit or does anyone just sell the washers.

i hope this makes sense,if not i'll get a pic up tonight to show the problem better

priv

adeshere · « **Reply #1 on:** July 17, 2007, 03:26 PM »

Cant you just use a normal washer ? or is it a special shape

pic would help

priv · « **Reply #2 on:** July 17, 2007, 07:08 PM »

a bit blured but i hope you get the idea

priv

Del · « **Reply #3 on:** July 17, 2007, 07:30 PM »

do you mean these Ady?

priv · « **Reply #4 on:** July 17, 2007, 08:07 PM »

that's them del,are they supposed to be so loose that i can take them out with my fingers

like this

or is there another washer that goes on top to seal it between to cones nut and bearing cup

priv

Del · « **Reply #5 on:** July 17, 2007, 08:10 PM »

no they should be a tight pressure fit, they're there to keep the bearing in/give them some protection from crud, the cone should spin freely within the hole of it.
Hope that makes sense

priv · « **Reply #6 on:** July 17, 2007, 08:50 PM »

Thanks del,if i get a new axle kit would that fix it?

priv

Del · « **Reply #7 on:** July 17, 2007, 09:06 PM »

if you want you can have those 2 cup washers, I dont need them. just pm me if you want them.