always use a good quality tea.
undo the locknuts, take out the cone and let the hub drop on your shed floor spreading bits of coater into hard to reach places. when u have gathered it all up it may look like this
then as if that werent difficult enough you get this as well.
stick the bits back together with grease....and slip it in the orifice
plop the driver in. and the bearing..small not big, thats already in...keep on yer toes now lads..
think about reading the instructions, then decide against it....
cone washer, washer and locknut..small not big....thats spare now....
align the sprocket thing with the 3 grooves...
pop the seal washer in and screw it in with your "special tool"
jobs a guddun!!!!
post thread on rad knowing full well that youll probably be the last person ever to do it, and probably the first since 1986...
cool as.
tune in next week when we split the atom, prove that black is white, and attempt to make a working volcano from bogroll and caustic soda.
