New Skool Headset !?!

[Stace]

Looks obvious but I'm being a bit careful 




The isn't any bearings in the top so do I just grease up??

Installation instructions very much appreciated?  & How do I fit the cups without fekin up the frame?

Ta
Stace 

[theRuler]

there should be bearings in the top mate!

just thwack the cups in

[Dingobmxer]

Stace, d is the top cartrdge bearing
Take the frame and headset to a shop and get them to fit it, they have proper tools to press the cups in and seat the bottom race on the fork crown
  DINGO

[theRuler]

hammer and block of wood are the tools you need

[dordymush]

lol i dont even use the wood.
just smash it  .

[spinmaster]

d is the bearing

[Moose]

As everyone has pointed out D is the top bearing (sealed cartridge type), you should also have a set of angular contact needle rollers for the bottom (F) and there should be a seal for the crown race (G).

The crown race on those Sky Pilots can be a bugger to fit careful you don't break it or it won't seal properly. I took my last one to my local shop and they let me use the correct tool to fit it myself (nice chaps).

[Stace]

Thanks guys,

Gonna take it in and get someone to do it !

[Dingobmxer]

hammer and block of wood are the tools you need

lol i dont even use the wood.
just smash it  .

Rough gits 

How it SHOULD be done:-
first ream and face the headtube to make it all nice and square,



then press in the cups



after determining the correct length cut he steerer down



then grease and pop together and it will run smooth and last longer
  DINGO

[zed4130]

wow there is a tool  i just use a hammer 

[theRuler]

over engineering or what

[Stace]

All Done !

I've now found a little rubber washer but not sure where it fell out of !! 

[Moose]

How small? Is it a rubber seal/washer for the allen bolt?

[Stace]

Same size as the crown race.

Is that the seal you were referring to

[Dingobmxer]

Nice setup there Dingo 

Bru 

its my mates shop I use Bru 
  DINGO

[Moose]

Same size as the crown race.

Is that the seal you were referring to

Probably. It should fit into the recess that's on the crown race