Author Topic: Mx1000s can you powdercoat after stripped (Read 1069 times)

d4vvs · « **on:** April 14, 2017, 01:39 PM »

Found a stripped set lying around would like them black but dont no if the plastic washer on levers will melt

rodriguez · « **Reply #1 on:** April 14, 2017, 02:38 PM »

powdercoating is too thick and not really worth the effort IMO, spray bomb if you must

tfi_friday · « **Reply #2 on:** April 14, 2017, 03:06 PM »

Quote from: rodriguez on April 14, 2017, 02:38 PM

powdercoating is too thick and not really worth the effort IMO, spray bomb if you must

It's possible to have them reanodized with the.plastic washers in situ.

d4vvs · « **Reply #3 on:** April 14, 2017, 10:19 PM »

Many thanks

rodriguez · « **Reply #4 on:** April 15, 2017, 05:33 PM »

Quote from: tfi_friday on April 14, 2017, 03:06 PM

Quote from: rodriguez on April 14, 2017, 02:38 PM
powdercoating is too thick and not really worth the effort IMO, spray bomb if you must

It's possible to have them reanodized with the.plastic washers in situ.

even better

tfi_friday · « **Reply #5 on:** April 16, 2017, 01:29 AM »

Quote from: rodriguez on April 15, 2017, 05:33 PM

Quote from: tfi_friday on April 14, 2017, 03:06 PM
Quote from: rodriguez on April 14, 2017, 02:38 PM
powdercoating is too thick and not really worth the effort IMO, spray bomb if you must

It's possible to have them reanodized with the.plastic washers in situ.

even better

Had this all redone, one lever was NOS and used for colour matching, but the other lever was done intact just needed the extra anodising off the pin removed (10 min job). For the rest the mx1000 Quick release and seat clamp pin needed removed and reinstalled.