Author Topic: Help! Removing my cranks (Read 1026 times)

WINI · « **on:** April 28, 2016, 10:17 AM »

Got a minty set of Profile cranks that are refusing to come off and I'm loathed to hit them to get them off. Are any of the advertised crank extraction tools good for mid 90's spline cranks? Just need to get one bloody arm off!

pickle · « **Reply #1 on:** April 28, 2016, 11:05 AM »

Put it back in the BB and hit the axle through?

WINI · « **Reply #2 on:** April 28, 2016, 01:29 PM »

Quote from: pickle on April 28, 2016, 11:05 AM

Put it back in the BB and hit the axle through?

Might be worth a crack. I've got an extractor tool from a mate, but it relies on a thread which I don't think they have. Not having a garage or vice anymore isn't helping either

john4130 · « **Reply #3 on:** April 28, 2016, 05:36 PM »

take out the bolt from the side you want to take the arm off, then tighten the bolt holding the other arm. this will get the arm moving, the profile crank tool is the best tool for the job but if you don't have it then a socket extension bar and a hammer will do the job.

dancetothedrummersbeat · « **Reply #4 on:** April 28, 2016, 08:22 PM »

Quote from: WINI on April 28, 2016, 10:17 AM

Got a minty set of Profile cranks that are refusing to come off and I'm loathed to hit them to get them off. Are any of the advertised crank extraction tools good for mid 90's spline cranks? Just need to get one bloody arm off!

You're welcome to borrow mine Mark, as long as I get it back of course!

WINI · « **Reply #5 on:** April 28, 2016, 08:30 PM »

Quote from: dancetothedrummersbeat on April 28, 2016, 08:22 PM

Quote from: WINI on April 28, 2016, 10:17 AM
Got a minty set of Profile cranks that are refusing to come off and I'm loathed to hit them to get them off. Are any of the advertised crank extraction tools good for mid 90's spline cranks? Just need to get one bloody arm off!

You're welcome to borrow mine Mark, as long as I get it back of course!

Thanks Andy, I've just got them off thanks to Johns advice. Socket extension on the opposite side spindle and a good few whacks did the job a treat.

Cheers both!

Wini