Author Topic: ALLY HUB TUFF REBUILD.... (Read 1046 times)

deeman · « **on:** January 20, 2016, 04:12 PM »

I am rebuilding my front ally hubbed Tuff ....I was wondering how to get the old bearing cups out? I tried a screwdriver and a whack like a bb cup and it did not move but I didn't want to go too mad in case I damaged the hub. Am I tackling it right or is there another way of going about it? any help appreciated...
Damo

oldschoolace · « **Reply #1 on:** January 20, 2016, 04:18 PM »

Pretty sure you just knock them out Damo. Just make sure you have the wheel hub well supported. I dont think its a job that can be done with any reall finesse

deeman · « **Reply #2 on:** January 20, 2016, 07:19 PM »

Quote from: oldschoolace on January 20, 2016, 04:18 PM

Pretty sure you just knock them out Damo. Just make sure you have the wheel hub well supported. I dont think its a job that can be done with any reall finesse

Thanks Clint, I will stop touching it up and fooking whack it then!

oldschoolace · « **Reply #3 on:** January 20, 2016, 07:31 PM »

You could carefully take a Dremel cutter to it if you get stuck but it should pop out ( with a big whack!)
make sure you work your way round so it comes out square

58 delray · « **Reply #4 on:** January 21, 2016, 09:22 AM »

the raised portion of the outside of the hub needs to be placed on something like suitably sized socket or a vice opened to the correct size so that when you knock the cup out you dont push the hub flange out as well

deeman · « **Reply #5 on:** January 21, 2016, 11:03 AM »

Quote from: 58 delray on January 21, 2016, 09:22 AM

the raised portion of the outside of the hub needs to be placed on something like suitably sized socket or a vice opened to the correct size so that when you knock the cup out you dont push the hub flange out as well

Thanks Andy