Author Topic: Removing bearings from TNT hubs (Read 1098 times)

CustardLips · « **on:** November 23, 2015, 01:08 PM »

Need to get the bearing cups/cases out of these so i can get them re-anoed.

They seem to be set up like a bottom bracket... cups/cases are tapped in at either end with a spindle cover/spacer sat between the two. So the question is do i tap em out in the tradition bb cups way or is there another way ?
Has anyone done this before ?

Thanks.

rooski · « **Reply #1 on:** November 23, 2015, 01:37 PM »

Not done these before, but I imagine its a tap em out like a US bb as you say

Twenty inches of freedom · « **Reply #2 on:** November 23, 2015, 02:27 PM »

A blind bearing puller or a slide hammer with an expander on the end would be ideal but you need the tools, or apply some heat to aid tapping them out

nosepickben · « **Reply #3 on:** November 23, 2015, 04:00 PM »

I did it the Bb way. Just prise the spacer out of line a little, I used a small Allen key, 3mm or so, then gently tap out with a screwdriver. I put new bearings in mine when I got them as the rears were goosed, very surprised to see that dinky spacer tube in there!