Author Topic: Fitting motorcycle grips with a 1 inch throttle bore? (Read 693 times)

oldschoolace · « **on:** April 28, 2015, 07:42 PM »

Seen some grips I like but one is 7/8th bite and the other is 1 inch for a throttle.

Anyone ever fitted these and have any ideas about making up the difference besides using electricians tape?

rodriguez · « **Reply #1 on:** April 28, 2015, 07:49 PM »

Buy two pairs and use the two smaller ones

Retrodan72 · « **Reply #2 on:** April 28, 2015, 07:50 PM »

Buy two pairs and use the two smaller ones

Just about to suggest the same, of they're not too expensive that is.

oldschoolace · « **Reply #3 on:** April 28, 2015, 08:02 PM »

Did think that and they are fairly reasonable but with postage from the states it makes me think twice $:-\$

Gnarlyscoots · « **Reply #4 on:** April 28, 2015, 08:33 PM »

Cut into a strip and wrap an old inner tube around the bar end before putting the grip on Clint

johnjo74 · « **Reply #5 on:** April 28, 2015, 09:26 PM »

Cut into a strip and wrap an old inner tube around your bell end before putting the grip on Clint