Decals wont stick?

[hokuspokus74]

I Have a set off silver backed hutch decals and they wont stick,is there anything that can be used to stick,i tried sellotape but its rubbish to do it with you guys had any probs like this & how did you overcome the situation?

[Retrodan72]

I Have a set off silver backed hutch decals and they wont stick,is there anything that can be used to stick,i tried sellotape but its rubbish to do it with you guys had any probs like this & how did you overcome the situation?

Use a hair dryer to heat the decal up, then place it in position.

Foil's tricky as its so thin, make sure your tubing is clean and free from any grease.

[hokuspokus74]

Cheers Dan, i know my luck the hair dryer will probably melt the foil lol just hope there is enough sticky left on the decal for it too work

[Retrodan72]

Cheers Dan, i know my luck the hair dryer will probably melt the foil lol just hope there is enough sticky left on the decal for it too work

Don't go too hot, or try heating the tube.

[hokuspokus74]

Why what happen if ya heat up the tube? will it melt them or what?

[Retrodan72]

Why what happen if ya heat up the tube? will it melt them or what?

No, just so you don't wreck your decals, you only need enoughh temp to get the glue working again, not melt anything.

[hokuspokus74]

so will i heat up the decals and the tubes or just the decals?

[Retrodan72]

so will i heat up the decals and the tubes or just the decals?

I don't know, it's very late now, and I've forgotten what the question was. 

[hokuspokus74]

  i'll just heat the decal and see how it goes from there cheers buddy