Author Topic: Tioga Beartrap BB Question (Read 1085 times)

monkian · « **on:** August 02, 2014, 05:31 PM »

Got this Tioga CK-170BT BB Set...
Never used one before but should the Adjusting Cone & Stationary Cone be the same?
Other BB Sets tend to have different Cones (usually one with integral nut & one with a notch type thing).
Has anyone else got one of these Sets to compare with? $:-\$

snoopy72 · « **Reply #1 on:** August 02, 2014, 08:08 PM »

looks like 2 of the same side, is one a right hand thread and one a left ? do they both screw on the shaft ?

monkian · « **Reply #2 on:** August 02, 2014, 08:40 PM »

All fits together Ok. You can use either one on either side.

snoopy72 · « **Reply #3 on:** August 02, 2014, 09:28 PM »

Well in that case, they probably made them both the same style because it's cheaper to make one type rather than two types or they put 2 left hand ones in the box by mistake , have you tried google imaging the part number and see if they are all like it.

monkian · « **Reply #4 on:** August 02, 2014, 09:45 PM »

Yeah, could well be the case

I had trouble finding a decent image online and the Tioga Catalogue only shows one side.
I've just found an early Tange CK-170 Set in my stash and that has x2 of the same Cones on it but it'd be good to see a like-for-like comparison.
It'll probably work alright but I'd just like to know if they're all the same.

I found this shot, which is hard to tell be could the same:

snoopy72 · « **Reply #5 on:** August 03, 2014, 06:59 AM »

I had an original 80's CV-170 They were different threads but had the same adjusting nut on both sides (identical) even though only the left side was adjustable (less machining costs)