0 Members and 1 Guest are viewing this topic.
good first attempt, now strip them and start again. build them 4x and make sure the valve hole isn't in between where the spokes cross.
Quote from: john4130 on December 29, 2013, 04:01 PMgood first attempt, now strip them and start again. build them 4x and make sure the valve hole isn't in between where the spokes cross. Nice spot there John.
Almost there.. But turn rim two spoke holes - either direction. If you got spoke cross over above valve hole then the spokes are in the wrong holes.. And you will damage the nipples! Also I would be surprised if 183mm will be long enough to lace 4X
Always start with the 1st spoke going in the hole on the right hand side of the valve hole But apart from that, good work