Author Topic: What's the best way to remove (Read 636 times)

Miley · « **on:** November 17, 2013, 08:03 PM »

Sealed (redline) bearings from a bottom bracket?
Thanks
Miles

Munnyella · « **Reply #1 on:** November 17, 2013, 08:14 PM »

knock them out through the spindle hole, using something softer than the bearing cups, I always start with a length of 15mm copper pipe and a lump hammer, if they don't move with that, Ill use a length of hardwood and a mallet, if that wont shift them, 14mm axle and metal hammer, worry about the marks after!!

MM

Bob_Acid · « **Reply #2 on:** November 17, 2013, 08:33 PM »

That about sums up my experience too although i usually start with the wood. 9 times out of ten though i end up smashing hell out of it with a steel rod.