fork crown race not snug

[Jim]

ok so I replaced my copy landing gear with some stamped landing gear. the fork crown popped off the old forks with a wee bit of force but when I put it on the new forks its not a snug fit. I slipped the bearings on and rebuilt and it seems fine no wobbles? anyone has a similar issue or advice it would be gratefully received.....

[Sid1972]

Often happens. Cut down a coke can and wrap a couple of centimeters round the base of the forks and tap the crown back on.

[Jim]

I'll probably cut myself to ribbons but shall try cheers sid 

[Munnyella]

If it fits ok, with no wobbles then you have no issues, if it slips a bit, do the can thing. I used to find that cheaper headsets were always a bit easier to fit the crown race on, but harder to get the cups in.

MM

[BENDYCAT ELEVENTEEN]

yer there is a chance that the ring will just spin round the fork tube and dig in and cut it 

[Bob_Acid]

At least one of my bikes has a beer can shim on the fork race 

[Jim]

All done no blood.....one snug race and one happy chappy