Shimano DX bearings

[wildon]

So i'm putting back together a set of DX.  got all the bearings here and there are 2 different sizes.  which size go where?  larger ones nearer the pedal boss or the end cap end? 

[wildon]

anyone?

[Dannywhac]

Don't think I've ever seen em with two different sizes of bearings? Then again not done loads of em, think the one's I've done were 4mm bearings either side.

At a guess I'd say bigger bearings near the crank arm, small at the end cap end? Edit - check a bearing next to the runner groove on the spindle/bolt - you should be able to see in profile which size bearing will fit where

[wildon]

Cheers.

I built these before and got it the wrong way around as they just didnt fit right .. but forgot which way around that was.  Just trying to get a heads up so i dont have to strip them down again 

[Rabdul06]

I just built a set of DX up yesterday and the bearings were all the same size (11 in each end 22 total per pedal) ...not sure whats going on with yours?! 

[wildon]

fook knows then .. they came out survivor pedals 

[Dannywhac]

There's a thread on here were Pickle says he's got a pair with different size bearings, and think the big un's go on the cap end?

[wildon]

11 a side but they defo different sizes

[NORTY40]

   fook me ..... they look like cannon balls 

I have a set of survivors on the way, should be here Wednesday so i'll check them

[wildon]

I put the larger ones in the crank end and they ok 

[kalex]

i've not long repacked some dx's and all the bearings were the same size