any one running gsport hubs

[harris]

i just replaced rear spindle and bearings but it looks a tad strange to me
or is it new school hub set up i am not use to.one side sticks out alot more than they other

[Wayne Ryder]

I've got an old Homer with the tapered spacer (on the non-freewheel side), it looks slightly different from yours. After adding a washer to the axle on the opposite side, it was pretty symmetrical. I see yours protrudes enough already, though.
I don't think yours are too far out if you were to measure in each direction from the centre of the hub.

[harris]

i will measure cheers chap it does fit into the frame ok.on the sprocket side the bearings are
inside the hub strange to me it has to be inserted from the other side and held in with a clip

[harris]

i just measured it is spot on center to center