Decals not sticking?

[paulb113]

Hi

My bike has been done by superbikedan and new Haro original decals on but they are all starting to come away at the edges, I assume its because they are old? Is there anything I could use to stick them back with?

Thanks
Paul

[deeman]

did you de- grease the frame before decals were applied?clear nail varnish should do the trick

[Retrodan72]

Hi

My bike has been done by superbikedan and new Haro original decals on but they are all starting to come away at the edges, I assume its because they are old? Is there anything I could use to stick them back with?

Thanks
Paul

What Damo said, although my street beat frame that Dan did for me was free of any grease.

Where did you try to apply them? They won't adhere if you try it in a cold, damp garage. Get the bike in the house at room temp, that should help. 

[wildon]

The og seat stay decals on my judge peel up too. Have keep rubbing them back down. Must be cause they old I suppose. They went over new powder.

[dordymush]

i always warm any stickers up with the missus,s hair dryer to make em stick a bit better.

[GavinDavis]

i always warm any stickers up with the missus,s hair dryer to make em stick a bit better.

Nice touch 

I usually go all out hardcore and peel the whole lot from the backing, then realise I actually need 3 hands 

[Jaan]

i always warm any stickers up with the missus,s hair dryer to make em stick a bit better.

+1

Gets the glue a little more tacky but doesn't leave you much room for manoeuvre 

[paulb113]

Thanks for all the info

My mate BADDH built if for me, so not sure about a de grease or where it was built.

[Andy68]

I always use Spray Mount on old stickers to give em a bit more grab, seems to work ok. 

[Peter J]

i always warm any stickers up with the missus,s hair dryer to make em stick a bit better.

Don't tell fibs its your hair dryer 

The gum on OG decals has normally gone off a bit (they are bloody old remember    so may need a little help sticking down