Whats missing? Help please!

[bmxgirl]

Basically what goes on next? apart from the obvious handlebars lol
The forks are tightly in place and wont fall out but i don't know what other bits are missing!

[wildon]

supposed to be just the top nut but you have loads too much thread left over there .. you gonna need to cut some off or whack a load of washers on before the top nut

[leehunt1]

Take your pick, Hot or Cold 

[bmxgirl]

lol @ above!
Wildon - yes thats what i thought. I guess maybe it was meant to have a gyro which would fill the gap. Ile have to just put spacers on.

[wildon]

gyro still wouldnt fill the gap .. they move up and down over the headset

[stuntmaster]

yep shouldn`t have that much thread left , you could use spaces but odd that it has so much thread left

[wildon]

prob a stupid question but the cup, crown race and bearings are on the bottom of the headtube right?

[bmxgirl]

Not a stupid question at all. As far as i know those bits are on the bottom. Whats a crown race tho ? 

[Taipan]

Mind the gap! 

[ED209]

different headsets look different! but essentially you need all these bits

[Bob_Acid]

It looks like your fork steerer is too big for your head tube.

Are A-head head tubes smaller than inch ones? I only ask as the Giro lug points to it being a new skool frame which don't usually have threaded forks.

[not johndub71]

Stick a few ahead spacers in then fit top bolt.

[ED209]

more pics and info on the bike needed 

[pickle]

It looks like your fork steerer is too big for your head tube.

Are A-head head tubes smaller than inch ones? I only ask as the Giro lug points to it being a new skool frame which don't usually have threaded forks.

I think you may have it there Bob, 1 1/8th headtube/headset with threaded forks 

[GavinDavis]

It has to be a 1 1/8th headset as it looks to be using a compression ring to take up the slack of the steerer inside the head tube 

What bike is it?

[Munnyella]

1&1/8 threaded?  I've got some mongoose ones, mine has the stem next, then a fook off big top nut to compress it all down, horrible, but works.

May not be enough thread if thats the case....


MM

[bmxgirl]

The bike is a Reef Boss (yes i know pos)! But i enjoy i building parts bin specials, although if i can't fit the forks ile give up!
Heres what i have...