zeronine stadium plate to cw bars

[markyp]

ok, i can see now why my mate bitd chopped off the top  tabs of his zeronine so that it would fit straight across the top of his cw bars,but my question is how the fook do you get those top tabs to stay velcroed down,the sizes are all wrong,do you need longer velcro to get the leverage and im guessing you have to bend the life out of the top tabs to train them to stay back?any help appreciated chaps

[Gnarlyscoots]

Just sell that plate to me Mark and all your problems will be resolved buddy 

[Andy68]

Just sell that plate to me Mark and all your problems will be resolved buddy 

But then you'll struggle, get angry and want rid so just sell it to me Mark!!! 

[markyp]

thats one solution but not alot of help

[steve69]

I put a 'moto-control' on mine for the same reason.


that's not a lot of help either  but i wouldn't chop the ears of it and spoil a good plate

[dordymush]

i heated up my one bitd with a hair drier to get the bend.
but the plates were only about a tenner back then so never bothered about fooking it up 

[markyp]

i reckon cable ties would do the job,underneath the velcro

[stevochb]

i reckon cable ties would do the job,underneath the velcro

X2 

[M5AT]

Yeah, I chopped the ears off mine BITD, think everyone did, just stick it on like this?

[markyp]

im gonna cable tie it,been looking at pics from bitd and the pros seem to have been able to bend the ears over the cw's

[dordymush]

they do look better bent over the bars.
but go steady cause they crack real easy 

[hunterdubber]

Andy Patterson used to run Zeronine plates on CW's bars on his T/A

tabs cut off 


But I immediately thought the same as Dords

get the hairdryer on it 

A good  blowjob works everytime 

[hunterdubber]