Author Topic: My first wheel build for my first project (Read 1032 times)

lukethespookcoop · « **on:** June 21, 2012, 04:42 PM »

I think I've got this right, was a bitch but enjoyed it none the less, took the whole evening, followed YouTube instructions but were never right, then I just copied the other wheel and it worked out fine, all nice and tight.

Bigfrawg · « **Reply #1 on:** June 21, 2012, 04:48 PM »

Something looks a bit squiffy there , could be my eyes though $:-\$

BADDH · « **Reply #2 on:** June 21, 2012, 09:04 PM »

I agree something wrong there buddy, it's mind boggling
doing these but once you've done one it's much less hastle

Laced mine up 3 times before I got it right.

nearly threw them over the fence ....

In2 bmx · « **Reply #3 on:** June 21, 2012, 09:17 PM »

Ive never tried .

but Good effort .. something don't look right to me ...

lukethespookcoop · « **Reply #4 on:** June 21, 2012, 09:30 PM »

I see what you mean!, I'm not sure if it's a bad photo!, I took last night at 11:30 when I eventually finished!, I'm gonna check it again when I get home and report, I'm sure it looked fine!, hopefully it's just the angle of the photo.

motomagII · « **Reply #5 on:** June 21, 2012, 09:31 PM »

yeah they are wrong sorry the sopke heads are opposite way to what they should be i think ,not 100 percent sure though

lukethespookcoop · « **Reply #6 on:** June 21, 2012, 09:36 PM »

Cool, I shall check again when I get home, and if they're wrong spend my whole Sunday tryna perfect it, I think the only time I get a little confused is when you have to turn it over and go to the hole that is to the right and doesn't line up with the one below!!!, ha, that made sense to me.

Frosty · « **Reply #7 on:** June 21, 2012, 10:02 PM »

use Stidds guide on here somewhere, that is what I used and always return to

lukethespookcoop · « **Reply #8 on:** June 21, 2012, 10:41 PM »

Nice one I've just checked it against the original... One sides perfect the other side is wrong!, damn, I'm actually not tooooo pissed off, looking forward to correcting it then hopefully doing the second one easily!!.