Author Topic: tange norco frame (Read 1545 times)

motomagII · « **on:** August 30, 2005, 05:54 PM »

can anyone tell me owt about these as i have one on the way .looks like nice frameset .anyone seen any decals for it

?yes i know its long shot .pic of original one would be nice also cheers greg

looks very much like kuwahara in my view

daz bmx it! · « **Reply #1 on:** August 30, 2005, 07:26 PM »

Yoh Gregg! where you keep diggin these frames up from buddy?

you got a new project every week

Are there any aero shaped tubes on it? Couple of years ago i had a tange made frame similar in design tried for ages to id it ? got it down to either an unheared of or rare Kuwie? got fed up in the end and swapped it!

Waxintaxin · « **Reply #2 on:** August 30, 2005, 07:49 PM »

Yep tange made kuwys , and the aero pro. which has the same geo as a kuwy ,so that looks like the tange branded aero pro/kuwykz1? so maybe they used the same jigs and changed drop outs

my cromo burner again made by tange is exactly the same as a kuwy loop tail but with holes in the rear drop outs

who knows. but that is what i have found out as into my tange made burners

as the picture above looks like an aero pro as well as a kuwwy , but the drop outs are slightly different

Rich

motomagII · « **Reply #3 on:** August 31, 2005, 07:53 PM »

cheers mate doesnt help too much but may build it as a burner or a kuwahara or just a tange wicked race bike as all there frames were top notch in my view .boy they made some frames too .

jonpaul11 · « **Reply #4 on:** September 02, 2005, 06:17 PM »

Looks more like a Kuwi to me - but you never know with Tange Frames, so many for so many companies!

http://www.dreamgate.ne.jp/kuwahara/

That's the best Kuwi site - when looking at the pic of your frame my first thought was a 'Survivor', non loop tail, drop outs with 3 circles like the lazer Lite. Looks like you have a flat break plate so I don't think it's a Burner...

Daz - was the Tange frame you're talking about the one I took off you? I thought when I got it it was maybe an Aero Pro as drop outs and chain stays are the same - but it's not oval enough! I was also told maybe a Flying Rhino - but I thought they had a butted down tube... anyway.

My pics are below!

SAND N DIRT · « **Reply #5 on:** September 02, 2005, 06:22 PM »

Tioga Rhino III had the same frame, made by Tange...

Agu sport had the same frame (but not that seatposttube), made by Tange...

Alll made by Tange...

SND