Right put a dob of grease inside around the cup - this is so the loose bearings have some thing to stick to - you need to count how many (can't remember how many off hand ) for each side
the with the axle - put one cone nut on it (the big nut with curved front) the shields go over the cone nut (i see you have one on already) - there seems to be the original cover missing
this will lock the bearing down
grease up the other side and bearing in - the cone nut down the axle up to the bearings
then it's a small hex nut up to each cone nut - these now need to be dial in - tighten one side up to each other - then the other cone nut goes up to the bearings and other nut up to the cone nut - you need to have a play on how tight it is and needs to spin - then it's on the forks and washer and nut to tighten
and now for the pic's - hope this helps - cheers B
