Author Topic: Fancy a screw...?! (Read 704 times)

Devilock · « **on:** April 25, 2012, 06:54 PM »

Basically one of the screws on my XC II's has been slightly rounded off so what solutions do you lot have for removing the bastard?

WARDY · « **Reply #1 on:** April 25, 2012, 06:58 PM »

animal · « **Reply #2 on:** April 25, 2012, 07:04 PM »

Nice punch there Mikey

I drill a small hole through the screw being very careful not 2 drill straight through the ally body aswell

then hammer a tight fitting alley key into the hole and that should get it out by turning very carefully . Try and tighten it a little first as this normally cracks the stickyness

Devilock · « **Reply #3 on:** April 25, 2012, 07:52 PM »

Quote from: Wardy on April 25, 2012, 06:58 PM

Already tried that machine!!

Quote from: ANIMAL on April 25, 2012, 07:04 PM

Nice punch there Mikey

I drill a small hole through the screw being very careful not 2 drill straight through the ally body aswell then hammer a tight fitting alley key into the hole and that should get it out by turning very carefully . Try and tighten it a little first as this normally cracks the stickyness

Cant tighten it as the head has been rounded off... Ill try the drill method...when I get a drill!!!