Author Topic: Anybody out there who can retap theads? (Read 1123 times)

Superkav · « **on:** February 15, 2012, 10:33 PM »

I've got a Hutch spindle with a bad thread that has just knackered the new button screw I tried to put in it. the other pedal was fine so I know the screws are good.

Anybody? I don't have a local metalworks that will do such a small job (not that 've found so far anyway)

Cheers
Supes

1mancity2 · « **Reply #1 on:** February 16, 2012, 09:48 AM »

Just buy a tap and do it yourself.

Superkav · « **Reply #2 on:** February 16, 2012, 04:53 PM »

Does it need to be a certain size tap? I should probably google it before I typed this

animal · « **Reply #3 on:** February 16, 2012, 05:24 PM »

At a guess I would say UNC thread possibly 7/16th

But I will stand correcting

HUTCHMAN · « **Reply #4 on:** February 16, 2012, 07:29 PM »

i take it by using a button head screw your talking about the other end from the crank? 7/16 is .4375" ,just under 1/2 inch,prob more like 3/16(.1875,just over 4.75mm) but Animal is right,most likely UNC,or maybe UNF depending on thread pitch.