Evening all,
Think this question was asked a while back(but not sure
), i bought a set of used lavender Z's from across the pond a few months back & have stripped em down. They have the original acs Z hubs(small flange), i bought some white spokes/nipples from the states. They are 194m/m in length, but on closer inspection the original one's i took off are 186m/m in length
. have i screwed up?
Can anyone tell what the correct length should be?
I have thought that maybe i could run a 2m/m die down the spokes to extend the threaded area & then cut down to length
Note: i may have my measurements back to front......could be new(196m/m) & old(184m/m). What a plank eh!!.....turned 40 back in October & memory turning to mush
Cheer's guy's,
Buz