0 Members and 1 Guest are viewing this topic.
. I used a blow torch 2 reinvigorate the mixture .
Quote from: ANIMAL on November 01, 2011, 09:28 PM . I used a blow torch 2 reinvigorate the mixture . a few deep breaths over the end of the hole just to check the mixture is working too ...... you should feel a slight burning sensation around the inner lung area Good luck Fraz , it does work
U don't need a lot of crystals buddy bit at a time fella I have done loads and it always works Helps if it isn't done outside in the cold . I used a blow torch 2 reinvigorate the mixture . Plus every time u do a mix flush out all the gunk then start again murder that ally post fella
cheers , will keep at it then was about to give up and try to get it drilled out somewhere , hopefully won't have to ever use the sh1t again after this, chemicals and me is just not a good idea
i always use liquid concentrate caustic .just fill and watch it go!!it is industrial caustic liquid tho
Quote from: paddy2 on November 02, 2011, 03:07 PMi always use liquid concentrate caustic .just fill and watch it go!!it is industrial caustic liquid tho where do you get that from
not worked yet, the thinned remnants are still stuck to the edges of the seatpost tube,I can now get a post in far enough if I cut it down, so may just do that