Author Topic: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS (Read 619 times)

HARORIDER · « **on:** May 17, 2011, 04:19 PM »

as skyways have 10mm axles would it be ok to just put them in and tighten up or use a 10-14 axle convertor? trouble is i've only seen threaded versions which do not fit the skyway thread-anyone done this already? what did you do?

Paul

Jaymz · « **Reply #1 on:** May 17, 2011, 04:37 PM »

get the little washers that convert 10mm to 14mm, cheap enough

HARORIDER · « **Reply #2 on:** May 17, 2011, 04:48 PM »

Quote from: Jaymz on May 17, 2011, 04:37 PM

get the little washers that convert 10mm to 14mm, cheap enough

where from $:-\$

kuwahero · « **Reply #3 on:** May 17, 2011, 04:54 PM »

http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567

Jaymz · « **Reply #4 on:** May 17, 2011, 04:56 PM »

Quote from: kuwahero on May 17, 2011, 04:54 PM

http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567

HARORIDER · « **Reply #5 on:** May 17, 2011, 09:35 PM »

cheers guys

spesh · « **Reply #6 on:** May 18, 2011, 08:33 PM »

i have a full set of front and rear axle converters (threaded) specifically for skyways 36/24 tpi
i had them on my haro zippo after using washers but they kept slipping in the drop outs so i bought the converters
as it was a rider
pm me if your interested