I've a pair of new Skyway Tuff IIs with a coaster and I'm looking to put pegs on the front and back. Trouble is the axles are different: I'm pretty sure they're both 3/8ths but one is 24TPI and one is 26. I think. Does anyone know for sure as I only have a metric thread gauge? As for the actual pegs I'm after, could anyone recommend a set that also doubles up as the wheel nut (so I can maximise how much axle goes into the peg)? And I'd rather they weren't too large in diameter. I quite like the Skyway pegs from BITD but can't seem to find any - anyone know if they were front/rear specific or where there's a couple of pairs up for grabs? Or if there's a modern equivalent?
Questions questions ...
See you at Corby,
Gordy