Deacals

[tobytyke]

Applied decals to my build following the link on the forum, in daylight though i have noticed a couple of air bubbles still  , is there  any tips for safely removing them so i can reapply   

[meticulous]

its too late now....

[bobafett]

Try warming them up with a hairdryer - makes em easier to peel off  

[ozone]

I used to burst the bubbles with a pin when I was a kid.   

[brummie]

id perhaps try and gently heat them up with a hairdryer and try and chase the bullble out by pushing them to the edges of the decal 

[southern andy]

You may have to do what Ozone suggested.

Get the thinnest pin you can find and just touch the bubble lightly so it pierces a minute hole then press the decal down. The air will escape out the hole and your decal will stick. try piercing it where it will be less seen.

I'd be very surprised if you saw the hole after that.


A hair dryer heating the sticker up to remove again will probably only stretch the vinyl, its defo shagged then.