gfxgfx
 
logo
 
gfx gfx
gfx
975811 Posts in 138943 Topics by 6371 Members - Latest Member: Robertflamn November 30, 2024, 07:20 AM
*
gfx* Home | Portal | Forum | Merchandise | Help | Login | Register | gfx
gfx
RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  Ody Driver fitting
gfx
gfxgfx
 

Author Topic: Ody Driver fitting  (Read 660 times)

0 Members and 2 Guests are viewing this topic.

Stella Dave

  • Guest
Ody Driver fitting
« on: June 02, 2010, 08:58 PM »
Took my Ody 10t driver off to remove the grease I'd put in as it was sticking a wee bit.

When putting it back in and the nut on hand tight the driver is very stiff! As soon as it tightens it goes against the rubber seals and gets stiff.

Cant see any other way to put it in but I dont rem it being that stiff before.

Any fitting guides please??

Offline Gary72

  • Site Supporter
  • BMX Nerd
  • *
  • Posts: 4218
  • Rated:
Re: Ody Driver fitting
« Reply #1 on: June 02, 2010, 09:47 PM »
Is there a collar that you have left out?
Goes between the bearings in the hub and the bearings in the driver.

Bettyswallocks

  • Guest
Re: Ody Driver fitting
« Reply #2 on: June 02, 2010, 10:00 PM »
What hub is it dude?

Odyssey have some instructions online

http://www.odysseybmx.com/techcorner/

Stella Dave

  • Guest
Re: Ody Driver fitting
« Reply #3 on: June 02, 2010, 10:38 PM »
It's a 1 piece for use with Hazard Cassette.

The axle has a step in it so it only goes in so far. I think I have to get the distance just right with the seal using the opposite axle nut??

RADBMX.CO.UK  |  Technical & Reference Section  |  Tech and Restoration  |  Ody Driver fitting
 

gfxgfx
gfx gfx
Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
SimplePortal 2.3.5 © 2008-2012, SimplePortal